282 citations · 1.3k across the 29 of their papers we have counts for
10 papers · 1 filter
Characterization of LAPPD timing at CERN PS testbeam
Deb Sankar Bhattacharya, Andrea Bressan, Chandradoy Chatterjee +11
Large Area Picosecond PhotoDetectors (LAPPDs) are photosensors based on microchannel plate technology with about 400 cm sensitive area. The external readout plane of a capaciti…
Evaluation of Planar Silicon Pixel Sensors with the RD53A Readout Chip for the Phase-2 Upgrade of the CMS Inner Tracker
The Tracker Group of the CMS Collaboration
The Large Hadron Collider (LHC) at CERN will undergo an upgrade in order to increase its luminosity to cms. The increased luminosity during this…
Upgrade of compact neutron spectrometer for high flux environments
M. Osipenko, A. Bellucci, V. Ceriale +9
In this paper a new version of Li6-based neutron spectrometer for high flux environments is described. The new spectrometer was built with commercial single crystal Chemical Vapour…
A Radial Time Projection Chamber for detection in CLAS at JLab
R. Dupré, S. Stepanyan, M. Hattawy +17
A new Radial Time Projection Chamber (RTPC) was developed at the Jefferson Laboratory to track low-energy nuclear recoils for the purpose of measuring exclusive nuclear reactions,…
Diamond Detectors for the TOTEM Timing Upgrade
TOTEM Collaboration, G. Antchev, P. Aspell +80
This paper describes the design and the performance of the timing detector developed by the TOTEM Collaboration for the Roman Pots (RPs) to measure the Time-Of-Flight (TOF) of the…
Performance of the TOTEM Detectors at the LHC
TOTEM Collaboration, G. Antchev, P. Aspell +79
The TOTEM Experiment is designed to measure the total proton-proton cross-section with the luminosity-independent method and to study elastic and diffractive pp scattering at the L…
Comparison of Fast Amplifiers for Diamond Detectors
M. Osipenko, S. Minutoli, P. Musico +9
The development of Chemical Vapour Deposition (CVD) diamond detectors requests for novel signal amplifiers, capable to match the superb signal-to-noise ratio and timing response of…
Edgeless Silicon Detectors for the TOTEM Experiment
G. Ruggiero
Silicon detectors for the Roman Pots of the large hadron collider TOTEM experiment aim for full sensitivity at the edge where a terminating structure is required for electrical sta…
Final Size Planar Edgeless Silicon Detectors for the TOTEM Experiment
E. Noschis
The TOTEM experiment will detect leading protons scattered in angles of microradians from the interaction point at the Large Hadron Collider. This will be achieved using detectors…
Tests of a Roman Pot Prototype for the TOTEM Experiment
M. Deile
The TOTEM collaboration has developed and tested the first prototype of its Roman Pots to be operated in the LHC. TOTEM Roman Pots contain stacks of 10 silicon detectors with strip…