32 citations · 89 across the 4 of their papers we have counts for
6 papers
Effect of alloying and microstructure on formability of advanced high-strength steels processed via quenching and partitioning
P. Xia, F. Vercruysse, C. Celada-Casero +10
The article focuses on the effect of alloying and microstructure on formability of advanced high strength steels (AHSSs) processed via quenching and partitioning (Q&P). Three diffe…
A new physical simulation tool to predict the interface of dissimilar aluminum to steel welds performed by Friction Melt Bonding
T. Sapanathan, N. Jimenez-Mena, I. Sabirov +5
Optimization of the intermetallic layer thickness and the suppression of interfacial defects are key elements to improve the load bearing capacity of dissimilar joints. However, ti…
Failure of refractory masonry material under monotonic and cyclic loading: crack propagation analysis
K. Andreev, Y. Yin, B. Luchini +1
Refractory masonry (refractories) is exposed to in-service loads of different types. To rationalise the masonry design and failure analysis, differences of failure under cyclic and…
High temperature in situ SEM assessment followed by ex situ AFM and EBSD investigation of the nucleation and early growth stages of Fe-Al intermetallics
T. Sapanathan, I. Sabirov, P. Xia +4
A dedicated in situ heating setup in a scanning electron microscope (SEM) followed by an ex situ atomic force microscopy (AFM) and electron backscatter diffraction (EBSD) is used t…
The sensitivity of the microstructure and properties to the peak temperature in an ultrafast heat treated low carbon-steel
M. A. Valdes-Tabernero, A. Kumar, R. H. Petrov +3
In this work, we investigate the sensitivity of the microstructure and mechanical properties of an ultrafast heat treated low carbon-steel to the peak temperature. In all studied c…
The effect of heating rate and soaking time on microstructure of an advanced high strength steel
M. A. Valdes-Tabernero, C. Celada-Casero, I. Sabirov +2
This work focuses on the effect of soaking time on the microstructure during ultrafast heat treatment of a 50% cold rolled low carbon steel with initial ferritic-pearlitic microstr…