29 citations · 57 across the 4 of their papers we have counts for
5 papers
A new physical simulation tool to predict the interface of dissimilar aluminum to steel welds performed by Friction Melt Bonding
T. Sapanathan, N. Jimenez-Mena, I. Sabirov +5
Optimization of the intermetallic layer thickness and the suppression of interfacial defects are key elements to improve the load bearing capacity of dissimilar joints. However, ti…
High temperature in situ SEM assessment followed by ex situ AFM and EBSD investigation of the nucleation and early growth stages of Fe-Al intermetallics
T. Sapanathan, I. Sabirov, P. Xia +4
A dedicated in situ heating setup in a scanning electron microscope (SEM) followed by an ex situ atomic force microscopy (AFM) and electron backscatter diffraction (EBSD) is used t…
High temperature mechanical properties and microstructure of hard TaSiN coatings
M. A. Monclús, L. Yang, I. López-Cabañas +7
Room and high temperature mechanical properties of reactive magnetron sputtered TaSiN coatings were measured using nanoindentation (between 25C and 500C). Fracture toughness was al…
The sensitivity of the microstructure and properties to the peak temperature in an ultrafast heat treated low carbon-steel
M. A. Valdes-Tabernero, A. Kumar, R. H. Petrov +3
In this work, we investigate the sensitivity of the microstructure and mechanical properties of an ultrafast heat treated low carbon-steel to the peak temperature. In all studied c…
Tensile deformation and fracture mechanisms of Cu/Nb nanolaminates studied by in situ TEM mechanical tests
Z. Liu, M. A. Monclús, L. W. Yang +3
The mechanisms of deformation and failure of Cu/Nb nanolaminates manufactured by accumulated roll bonding were analysed using in-situ TEM mechanical tests. Dog-bone small-scale ten…