RF bifurcation of a Josephson junction: microwave embedding circuit requirements
arXiv:cond-mat/0612576 · doi:10.1103/PhysRevB.76.014524
Abstract
A Josephson tunnel junction which is RF-driven near a dynamical bifurcation point can amplify quantum signals. The bifurcation point will exist robustly only if the electrodynamic environment of the junction meets certain criteria. In this article we develop a general formalism for dealing with the non-linear dynamics of Josephson junction embedded in an arbitrary microwave circuit. We find sufficient conditions for the existence of the bifurcation regime: a) the embedding impedance of the junction need to present a resonance at a particular frequency , with the quality factor of the resonance and the participation ratio of the junction satisfying , b) the drive frequency should be low frequency detuned away from by more than .
Submitted to Phys. Rev. B, 12 pages, 6 figures
References in corpus (2)
Cited by in corpus (35)
- Microwave photonics with superconducting quantum circuits
- Black-box superconducting circuit quantization
- Josephson junction-embedded transmission-line resonators: from Kerr medium to in-line transmon
- Tunable resonators for quantum circuits
- Response of the Strongly-Driven Jaynes-Cummings Oscillator
- Perspective on traveling wave microwave parametric amplifiers
- Effect of higher-order nonlinearities on amplification and squeezing in Josephson parametric amplifiers
- Anomalous transport in biased ac-driven Josephson junctions: Negative conductances
- Measuring the Decoherence of a Quantronium Qubit with the Cavity Bifurcation Amplifier
- Phase-locking transition in a chirped superconducting Josephson resonator
- Quantum noise limited microwave amplification using a graphene Josephson junction
- Engineering Purely Nonlinear Coupling with the Quarton
- Multiplexed Readout of Transmon Qubits with Josephson Bifurcation Amplifiers
- Superconducting resonators with voltage-controlled frequency and nonlinearity
- Detection of weak forces based on noise-activated switching in bistable optomechanical systems
- Broadband lumped-element Josephson parametric amplifier with single-step lithography
- Microwave-induced inverse Faraday effect in superconductors
- Superconducting qubits beyond the dispersive regime
- CNOT gates for fluxonium qubits via selective darkening of transitions
- A quantum model for rf-SQUIDs based metamaterials enabling 3WM and 4WM Travelling Wave Parametric Amplification
- A compact design for the Josephson mixer: the lumped element circuit
- Cratered Lorentzian response of driven microwave superconducting nanowire-bridged resonators: oscillatory and magnetic-field induced stochastic states
- Observing quantum chaos with noisy measurements and highly mixed states
- Broadband CPW-based impedance-transformed Josephson parametric amplifier
- Dynamic Quantum Tunneling in Mesoscopic Driven Duffing Oscillators
- Free Mode Removal and Mode Decoupling for Simulating General Superconducting Quantum Circuits
- Superconducting microwave resonators with non-centrosymmetric nonlinearity
- A three-dimensional Josephson parametric amplifier
- Quantum metrology of low frequency electromagnetic modes with frequency upconverters
- Kerr nonlinearity and parametric amplification with an Al-InAs superconductor-semiconductor Josephson junction
- Wireless Josephson parametric amplifier above 20 GHz
- Large gain quantum-limited qubit measurement using a two-mode nonlinear cavity
- Quantum dissipative dynamics of driven Duffing oscillator near attractors
- Theory of high-power excitation spectra of rf-SQUID
- Quantitative calibration of a TWPA applied to an optomechanical platform