Improved critical current densities in B4C doped MgB2 based wires
arXiv:cond-mat/0607073 · doi:10.1088/0953-2048/19/10/007
Abstract
An improvement of the transport critical current density, Jc, of MgB2 wires was obtained after addition of 10 wt.% B4C powders, after reaction at 800 C: Jc values of 1.10^4 A/cm2 at 4.2 K and 9T were obtained for wires of 1.11 mm diameter in a Fe matrix. The starting mixture of Mg and B was doped with sub-micrometric B4C, the ratio being Mg : B : B4C = 1: 2 : 0.08, corresponding to 10 wt.% B4C. For T > 800 C, a decrease of Jc was found, due to the reaction with the Fe sheath. In order to investigate the origin of the improvement of the transport properties for heat treatments up to 800 C, X-ray diffraction measurements were performed. A decrease of the lattice constant a from 0.30854 nm to 0.30797 nm was found, thus suggesting an effect of the substitution of Carbon on the properties of the wires. A comparison with the literature data shows that the addition of B4C powders leads to the second highest improvement of Jc reported so far after SiC, thus constituting an alternative for future applications.
18 pages, 8 figures, 1 table
References in corpus (4)
Cited by in corpus (7)
- Prospects for Improving the Intrinsic and Extrinsic Properties of Magnesium Diboride Superconducting Strands
- Strong enhancement of Jc in binary and alloyed in-situ MgB2 wires by a new approach: Cold high pressure densification
- Superconducting Properties of adipic acid doped Bulk MgB2 Superconductor
- Enhancement of flux pinning and high critical current density in graphite doped MgB2 superconductor
- Effect of PVA doping on flux pinning in Bulk MgB2
- Development of Doped MgB2 Wires and Tapes for Practical Applications
- Hollow carbon spheres as an efficient dopant for enhancing critical current density of MgB2 based tapes