Flux Jumping and a Bulk-to-Granular Transition in the Magnetization of a Compacted and Sintered MgB2 Superconductor
arXiv:cond-mat/0102320 · doi:10.1016/S0921-4534(01)00782-1
Abstract
The recent discovery of intermediate-temperature superconductivity (ITC) in MgB2 by Akimitsu et al. and its almost simultaneous explanation in terms of a hole-carrier-based pairing mechanism by Hirsch, has triggered an avalanche of studies of its structural, magnetic and transport properties. As a further contribution to the field we report the results of field (H) and temperature (T) dependent magnetization (M) measurements of a pellet of uniform, large-grain sintered MgB2. We show that at low temperatures the size of the pellet and its critical current density, Jc(H) - i.e. its M(H) - ensure low field flux jumping, which of course ceases when M(H) drops below a critical value. With further increase of H and T the individual grains decouple and the M(H) loops drop to lower lying branches, unresolved in the usual full M(H) representation. After taking into account the sample size and grain size, respectively, the bulk sample and the grains were deduced to exhibit the same magnetically determined Jc s (e.g. 105 A/cm2, 20 K, 0T) and hence that for each temperature of measurement Jc(H) decreased monotonically with H over the entire field range, except for a gap within the grain-decoupling zone.
7 pages, 6 figures, Changes: Fig 6 Vertical scale an order of magnitude out (changed figure and associated text). Also corrected typo in last section
References in corpus (6)
- Strongly linked current flow in polycrystalline forms of the new superconductor MgB2
- Boron Isotope Effect in Superconducting MgB
- Thermodynamic and Transport Properties of Superconducting
- Hole Superconductivity in : a high cuprate without Cu
- Temperature- and magnetic-field-dependent resistivity of MgB2 sintered at high temperature and high pressure condition
- Superconductivity from Hole Undressing
Cited by in corpus (21)
- Enhancement of the critical current density and flux pinning of MgB2 superconductor by nanoparticle SiC doping
- High transport critical current density above 30 K in pure Fe-clad MgB2 tape
- Dendritic magnetic instability in superconducting MgB2 films
- Effect of carbon nanotube doping on critical current density of MgB2 superconductor
- Substitution induced pinning in MgB_2 superconductor doped with SiC nano-particles
- Very fast formation of superconducting MgB2/Fe wires with high Jc
- Effect of nano-carbon particle doping on the flux pinning properties of MgB2 superconductor
- Superconductivity, critical current density, and flux pinning in MgB_{2-x}(SiC)_{x/2} superconductor after SiC nanoparticle doping
- The influence of microstructures and crystalline defects on the superconductivity of MgB2
- Properties of superconducting MgB_2 wires: "in-situ" versus "ex-situ" reaction technique
- Current-induced dendritic magnetic instability in superconducting MgB2 films
- Transport critical current of Solenoidal MgB2/Cu Coils Fabricated Using a Wind-Reaction In-situ Technique
- Superconducting screening on different length scales in high-quality bulk MgB2 superconductor
- The effect of sample size on field dependence of Jc for MgB2 superconductor
- Improvement of critical current density in the Cu/MgB2 and Ag/MgB2 superconducting wires using the fast formation method
- Dendritic flux avalanches in a superconducting MgB2 tape
- Transport Current in MgB2 based Superconducting Strand at 4.2 K and Self-Field
- Enhanced in eutectic high-entropy alloy superconductors Hf-Nb-Sc-Ti-Zr
- Uranium Doping and Thermal Neutron Irradiation Flux Pinning Effects in MgB2
- Water-Quenched Effects of 5 wt.% (Fe, Ti) particle-doped MgB Superconductor and Low Limit of Pinning Effect
- Delta H = Delta B region in volume defect-dominating superconductor