Planet Formation with Migration
arXiv:astro-ph/0610905 · doi:10.1086/510407
Abstract
In the core-accretion model, gas-giant planets form solid cores which then accrete gaseous envelopes. Tidal interactions with disk gas cause a core to undergo inward type-I migration in 10^4 to 10^5 years. Cores must form faster than this to survive. Giant planets clear a gap in the disk and undergo inward type-II migration in <10^6 years if observed disk accretion rates apply to the disk as a whole. Type-II migration times exceed typical disk lifetimes if viscous accretion occurs mainly in the surface layers of disks. Low turbulent viscosities near the midplane may allow planetesimals to form by coagulation of dust grains. The radius r of such planetesimals is unknown. If r<0.5 km, the core formation time is shorter than the type-I migration timescale and cores will survive. Migration is substantial in most cases, leading to a wide range of planetary orbits, consistent with the observed variety of extrasolar systems. When r is of order 100m and midplane alpha is of order 3 times 10^-5, giant planets similar to those in the Solar System can form.
12 pages including 4 figures
References in corpus (1)
Cited by in corpus (11)
- Planet formation around stars of various masses: The snow line and the frequency of giant planets
- Tidal Evolution of Close-in Extra-Solar Planets
- Magnetic fields in protoplanetary disks
- Ranges of Atmospheric Mass and Composition of Super Earth Exoplanets
- Gas disks to gas giants: Simulating the birth of planetary systems
- Coreless Terrestrial Exoplanets
- On the migration of protoplanets embedded in circumbinary disks
- Planet formation around stars of various masses: Hot super-Earths
- The effect of type I migration on the formation of terrestrial planets in hot-Jupiter systems
- Disk-Planet Interaction Simulations: (I) Baroclinic Generation of Vortensity and Non-Axisymmetric Rossby-Wave-Instability
- Flux-Limited Diffusion Approximation Models of Giant Planet Formation by Disk Instability