paper

Asymmetric Beam Combination for Optical Interferometry

arXiv:astro-ph/0103116 · doi:10.1086/320288

Abstract

Optical interferometers increasingly use single-mode fibers as spatial filters to convert varying wavefront distortion into intensity fluctuations which can be monitored for accurate calibration of fringe amplitudes. Here I propose using an asymmetric coupler to allow the photometric intensities of each telescope beam to be measured at the same time as the fringe visibility, but without the need for dedicated photometric outputs, which reduce the light throughput in the interferometric channels. In the read-noise limited case often encountered in the infrared, I show that a 53% improvement in signal-to-noise ratio for the visibility amplitude measurement is achievable, when compared to a balanced coupler setup with 50% photometric taps (e.g., the FLUOR experiment). In the Poisson-noise limit appropriate for visible light, the improvement is reduced to only ~8%. This scheme also reduces the cost and complexity of the beam combination since fewer components and detectors are required, and can be extended to more than two telescopes for "all-in-one" or pair-wise beam combination. Asymmetric beam combination can also be employed for monitoring scintillation and throughput variations in systems without spatial filtering.

13 pages, accepted by Publications of the Astronomical Society of the Pacific

References in corpus (3)

Cited by in corpus (9)