Accessible 3D Printed Archimedes System for Accurate and Precise Density Measurements and Uncertainty Analysis
arXiv:2611.17342
Abstract
Accurate and precise density measurements are important for characterizing solid materials and for evaluating physical properties that are strongly affected by porosity. While several methods are available for determining density, measurements of small or irregularly shaped samples can be limited by sample geometry, balance precision, liquid density, and other experimental sources of uncertainty. In this study, an accessible Archimedes density measurement system was developed using 3D printed components and an analytical balance for the measurement of solid and liquid densities. The measurement of solid densities requires knowing the exact density of the liquid. Therefore, copper, vanadium, and indium standards were used to measure the densities of ethanol (0.8116 +/- 0.0005 g/cm3), distilled water (0.9982 +/- 0.0013 g/cm3), and hexanes (0.6748 +/- 0.0016 g/cm3), all of them showing strong agreement with literature values. Uncertainty analysis indicates that the relative uncertainty in the measured solid density decreases with increasing sample mass and balance precision, while higher density liquids can further reduce the required sample mass. The uncertainty of the immersed mass measurement was found to have a greater influence on the calculated density than the uncertainty of the air mass measurement. An open-source Archimedes LS software was developed to analyse liquid and solid densities including the corresponding uncertainties. These findings demonstrate that an accessible 3D printed Archimedes system combined with an open-source software provides a practical approach for improving the consistency and comparability of density measurements between laboratories.
arXiv comment13 pages, 4 Figures