Flow and clogging of capillary droplets

Abstract

Capillary droplets form due to surface tension when two immiscible fluids are mixed. We describe the motion of gravity-driven capillary droplets flowing through narrow constrictions and obstacle arrays in both simulations and experiments. Our new capillary deformable particle model recapitulates the shape and velocity of single oil droplets in water as they pass through narrow constrictions in microfluidic chambers. Using this experimentally validated model, we simulate the flow and clogging of single capillary droplets in narrow channels and obstacle arrays and find several important results. First, the capillary droplet speed profile is nonmonotonic as the droplet exits the narrow orifice, and we can tune the droplet properties so that the speed overshoots the terminal speed far from the constriction. Second, in obstacle arrays, we find that extremely deformable droplets can wrap around obstacles, which leads to decreased average droplet speed in the continuous flow regime and increased probability for clogging in the regime where permanent clogs form. Third, the wrapping mechanism causes the clogging probability in obstacle arrays to become nonmonotonic with surface tension $\Gamma$. At large $\Gamma$, the droplets are nearly rigid and the clogging probability is large since the droplets can not squeeze through the gaps between obstacles. With decreasing $\Gamma$, the clogging probability decreases as the droplets become more deformable. However, in the small-$\Gamma$ limit the clogging probability increases, since the droplets are extremely deformable and cause clogs as they wrap around the obstacles. The results from these studies are important for developing a predictive understanding of capillary droplet flows through complex and confined geometries.

References in corpus (19)

• Jamming of Deformable Polygons
• Fraction of clogging configurations sampled by granular hopper flow
• Clogging in constricted suspension flows
• Clogging of soft particles in 2D hoppers
• Flow and clogging in a silo with an obstacle above the orifice
• The role of deformability in determining the structural and mechanical properties of bubbles and emulsions
• Intermittency and Velocity Fluctuations in Hopper Flows Prone to Clogging
• The structural, vibrational, and mechanical properties of jammed packings of deformable particles in three dimensions
• Clogging and Jamming Transitions in Periodic Obstacle Arrays
• Details of soft particle clogging in two-dimensional hoppers
• Lattice Boltzmann simulation of deformable fluid-filled bodies: progress and perspectives
• Silo discharge of mixtures of soft and rigid grains
• Controlled Fluidization, Mobility and Clogging in Obstacle Arrays Using Periodic Perturbations
• Hopper flows of deformable particles
• Clogging and avalanches in quasi-two-dimensional emulsion hopper flow
• Collective transport of droplets through porous media
• Directional Clogging and Phase Separation for Disk Flow Through Periodic and Diluted Obstacle Arrays
• Enhanced flow rate by the concentration mechanism of Tetris particles when discharged from a hopper with an obstacle
• Understanding the Local Flow Rate Peak of a Hopper Discharging Discs through an Obstacle Using a Tetris-like Model