First spectral emissivity study of a solar selective coating in the 150 to 600 C temperature range
arXiv:2401.12777 · doi:10.1016/j.solmat.2013.07.002
Abstract
A complete experimental study of temperature dependence of the total spectral emissivity has been performed, for the first time, for absorber reflector selective coatings used in concentrated solar power (CSP) systems for energy harvesting. The coating consist of double cermet layers of silicon oxide with different amounts of molybdenum over a silver infrared mirror layer. The experimental measurements were carried out by a high accurate radiometer (HAIRL) with controlled atmosphere in the mid-infrared and for temperatures between 150 and 600 C. The spectral emissivity is nearly constant in this temperature range. Therefore, the temperature dependence of the total emissivity is given by Planck function. These results were compared with those obtained with the usual calculus using room temperature reflectance spectrum. Finally, the performance of the coating was analyzed by comparison of coated respect to non-coated stainless steel.
arXiv comment6 pages, 10 figures
Cited by in corpus (3)
- Importance of the spectral emissivity measurements at working temperature to determine the efficiency of a solar selective coating
- Updated measurement method and uncertainty budget for direct emissivity measurements at UPV/EHU
- Thermal emissivity spectra and structural phase transitions of the eutectic Mg-51%Zn alloy: A candidate for thermal energy storage