Enhanced Thermoelectric Properties By Embedding Fe Nanoparticles Into CrN Films For Energy Harvesting Applications
arXiv:2304.07566 · doi:10.1021/acsanm.3c06054
Abstract
Nanostructured materials and nanocomposites have shown great promise for improving the efficiency of thermoelectric materials. Herein, Fe nanoparticles were imbedded into a CrN matrix by combining two physical vapor deposition approaches, namely high-power impulse magnetron sputtering and a nanoparticle gun. The combination of these techniques allowed the formation of nanocomposites in which the Fe nanoparticles remained intact without intermixing with the matrix. The electrical and thermal transport properties of the nanocomposites were investigated and compared to a monolithic CrN film. The measured thermoelectric properties revealed an increase in the Seebeck coefficient, with a decrease of hall carrier concentration and an increase of the electron mobility which could be explained by energy filtering by internal phases created at the NP/matrix interface. The thermal conductivity of the final nanocomposite was reduced from 4.8 W m-1K-1 to a minimum of 3.0 W m-1K-1 W. This study shows prospects for the nanocomposite synthesis process using nanoparticles and its use in improving the thermoelectric properties of coatings.
arXiv comment5 figures / 2 table
References in corpus (7)
- Theory of enhancement of thermoelectric properties of materials with nanoinclusions
- Effect of magnetic disorder and strong electron correlations on the thermodynamics of CrN
- Anomalous phonon lifetime shortening in paramagnetic CrN caused by magneto-lattice coupling: A combined spin and ab initio molecular dynamics study
- Effect of impurities on morphology and growth mode of (111) and (001) epitaxial-like ScN films
- Solid-state Janus nanoprecipitation enables amorphous-like heat conduction in crystalline Mg3Sb2-based thermoelectric materials
- Secondary Phase Limited Metal-Insulator Phase Transition in Chromium Nitride Thin Films
- P-type behavior of CrN thin films by control of point defects