Improvement in the Performance and Efficiency on Self-Deficient CaTiO${}_3$: Towards Sustainable and Affordable New-Generation Solar Cells

Abstract

Thin films of pure and self-deficient calcium titanites i.e., CaTiO${}_3$, Ca${}_{1-\alpha }$TiO${}_3$, CaTi${}_{1-\beta }$O${}_3$ and CaTiO${}_{3-\gamma }$ have been deposited on ITO substrate using dip coating method. X-ray diffraction and Scanning electron Microscopy (SEM) analysis confirm the structural and morphology of all deposited thin films. Photocurrent measurement has been done, and it is observed that during the incidence of UV light on the as-prepared device (i.e., in the "ON" state), a significant increase in photocurrent (IUV) at zero voltage was observed in case of O deficient CaTiO${}_3$, while in case of Ti and Ca deficient thin films smaller values of photocurrents were seen. Responsivity and detectivity of deposited thin films of all self-deficient CaTiO3 were found to be maximum in the UV region while they also showed smaller contributions in the visible range possibly due to the presence of self-deficiency. The self-deficient sample exhibits lower resistance (higher recombination rate) than the pure sample at low voltage, but at higher voltage, it is almost identical. Furthermore, theoretical calculations have been performed using the first-principles density-functional theory to validate the experimental findings on self-deficient CaTiO${}_3$. Incident-photon-to-current efficiency (IPCE) and current density have also been measured for all deficient CaTiO${}_3$ samples. Maximum IPCE have been found in the range 25%-28% for Ti and O deficient samples in the UV range (280- 400 nm). We argue that first-principles DFT calculations combined with the experimental measurements on self-deficient CaTiO${}_3$ thin films offer a reliable way to enhance the performance of perovskite-based solar devices.

arXiv comment18 pages, 9 figures (included)

References in corpus (7)

• Surface defects and conduction in polar oxide heterostructures
• Electron Correlation in Oxygen Vacancy in SrTiO${}_3$
• Magnetism and metal-insulator transition in oxygen deficient SrTiO${}_3$
• Highly Sensitive and Self Powered Ultraviolet Photo Detector based on ZnO Nanorods Coated with TiO${}_2$
• Elucidating the Influence of Native Defects on Electrical and Optical Properties in Semiconducting Oxides: An Experimental and Theoretical Investigation
• Anomalous electrochemical capacitance in Mott insulator titanium sesquioxide
• Effect of Pressure on Electrical and optical Properties of Metal Doped TiO${}_2$

Cited by in corpus (1)

• Enhanced UV Photodetector Efficiency with a ZnO/Ga${}_2$O${}_3$ Heterojunction