Estimating Ion Temperatures at the Polar Coronal Hole Boundary

Abstract

The temperatures of the heavy ions ($T_i$) in the solar corona provide critical information about the heating mechanism of the million-degree corona. However, the measurement of $T_i$ is usually challenging due to the nonthermal motion, instrumental limitations, and the optically thin nature of the coronal emissions. We present the measurement of $T_i$ and its dependency on the ion charge-to-mass ratio ($Z/A$) at the polar coronal hole boundary, only assuming that heavy ions have the same nonthermal velocity. To improve the $Z/A$ coverage and study the influence of the instrumental broadening, we used a coordinated observation from the extreme-ultraviolet Imaging Spectrometer (EIS) on board the Hinode satellite and the Solar Ultraviolet Measurements of Emitted Radiation (SUMER) on board the Solar and Heliospheric Observatory (SOHO). We found that the $T_i$ of ions with $Z/A$ less than 0.20 or greater than 0.33 are much higher than the local electron temperature. We ran the Alfvén Wave Solar Model-realtime to investigate the formation of optically thin emissions along the line of sight (LOS). The simulation suggested that plasma bulk motions along the LOS broaden the widths of hot emission lines in the coronal hole (e.g., Fe XII, Fe XIII). We discussed other factors that might affect the $T_i$ measurement, including the non-Gaussian wings in some bright SUMER lines, which can be fitted by a double-Gaussian or a $\kappa$ distribution. Our study confirms the preferential heating of heavy ions in coronal holes and provides new constraints on coronal heating models.

arXiv commentAccepted for publication in ApJ, 24 pages, 17 figures. Jupyter notebooks are available at https://github.com/yjzhu-solar/EIS_SUMER_PCH_Ti

References in corpus (25)

• SciPy 1.0--Fundamental Algorithms for Scientific Computing in Python
• Astropy: A Community Python Package for Astronomy
• The NumPy array: a structure for efficient numerical computation
• The Astropy Project: Building an inclusive, open-science project and status of the v2.0 core package
• Self-consistent Coronal Heating and Solar Wind Acceleration from Anisotropic Magnetohydrodynamic Turbulence
• Alfven Wave Solar Model (AWSoM): Coronal Heating
• Coronal Holes
• CHIANTI -- an atomic database for emission lines -- Paper XVI: Version 10, further extensions
• Solar UV and X-Ray Spectral Diagnostics
• High precision density measurements in the solar corona: I. Analysis methods and results for Fe XII and Fe XIII
• The effect of temperature anisotropy on observations of Doppler dimming and pumping in the inner corona
• On the interpretation and applicability of $\kappa$-distributions
• A revised radiometric calibration for the Hinode/EIS instrument
• Evidence of Wave Damping at Low Heights in a Polar Coronal Hole
• The Absolute Calibration of the EUV Imaging Spectrometer on Hinode
• Observational Quantification of the Energy Dissipated by Alfvén Waves in a Polar Coronal Hole: Evidence that Waves Drive the Fast Solar Wind
• Ion Temperatures in the Low Solar Corona: Polar Coronal Holes at Solar Minimum
• Non-Maxwellian analysis of the transition-region line profiles observed by the Interface Region Imaging Spectrograph
• Evidence for Wave Heating of the Quiet Sun Corona
• Solar off-limb line widths: Alfven waves, ion-cyclotron waves, and preferential heating
• The Effect of Solar Wind Expansion and Non-Equilibrium Ionization on the Broadening of Coronal Emission Lines
• Hinode EIS line widths in the quiet corona up to 1.5 Rsun
• Measurements of Anisotropic Ion Temperatures, Non-Thermal Velocities, and Doppler Shifts in a Coronal Hole
• Properties of a Polar Coronal Hole During the Solar Minimum in 2007
• Spectroscopic Measurements of the Ion Velocity Distribution at the Base of the Fast Solar Wind

Cited by in corpus (2)

• Propagating Kink Waves in an Open Coronal Magnetic Flux Tube with Gravitational Stratification: Magnetohydrodynamic Simulation and Forward Modelling
• Solar Flare Ion Temperatures