Data Flow in the Mu3e DAQ

Abstract

The Mu3e experiment at the Paul Scherrer Institute (PSI) searches for the charged lepton flavour violating decay ${\mu }^{+}\to e^{+}{e}^{+}{e}^{-}$. The experiment aims for an ultimate sensitivity of one in $10^{16}$ $\mu$ decays. The first phase of the experiment, currently under construction, will reach a branching ratio sensitivity of $2\cdot 10^{-15}$ by observing $10^8$ $\mu$ decays per second over a year of data taking. The highly granular detector based on thin high-voltage monolithic active pixel sensors (HV-MAPS) and scintillating timing detectors will produce about 100 GB/s of data at these particle rates. The Field Programmable Gate Array based Mu3e Data Acquisition System (DAQ) will read out the different detector parts. The trigger-less readout system is used to sort, time align and analyze the data while running. A farm of PCs equipped with powerful graphics processing units (GPUs) will perform the event reconstruction and data reduction. The paper presents the ongoing integration of the sub detectors into the DAQ, especially focusing on the time aligning and the data flow inside the FPGAs of the filter farm. It will also show the DAQ system used in the Mu3e Integration Runs performed in spring 2021 and 2022.

References in corpus (5)

• Technical design of the phase I Mu3e experiment
• Science Case for the new High-Intensity Muon Beams HIMB at PSI
• MuPix7 - A fast monolithic HV-CMOS pixel chip for Mu3e
• The Mu3e Data Acquisition
• Online Event Selection for Mu3e using GPUs

Cited by in corpus (1)

• Advanced muon-spin spectroscopy with high lateral resolution using Si-pixel detectors