Slip of submerged two-dimensional liquid-infused surfaces in the presence of surfactants
arXiv:2203.07773 · doi:10.1017/jfm.2022.835
Abstract
Using numerical simulations, we investigate the effects of Marangoni stresses induced by surfactants on the effective slip length of liquid-infused surfaces (LIS) with transverse grooves. The surfactants are assumed soluble in the external liquid shearing the surface and can adsorb onto the interfaces. Two different adsorption models are used: a classical Frumkin model and a more advanced model that better describes the decrease of surface tension for minuscule concentrations. The simulations show that LIS may face even more severe effects of surfactants than previously investigated superhydrophobic surfaces. Constructing an analytical model for the effective slip length, we can predict the critical surfactant concentration for which the slip length decreases significantly. This analytical model describes both adsorption models of LIS on a unified framework if properly adjusted. We also advance the understanding of when surfactant advection gives rise to highly skewed interfacial concentrations - the so-called partial stagnant cap regime. To a good approximation, this regime can only exist below a specific surfactant concentration given by the Marangoni number and the strength of the surfactants.
arXiv comment34 pages, 13 figures
References in corpus (8)
- Influence of the enclosed fluid on the flow over a microstructured surface in the Cassie state
- Substantial drag reduction in turbulent flow using liquid-infused surfaces
- Traces of surfactants can severely limit the drag reduction of superhydrophobic surfaces
- Transfer of mass and momentum at rough and porous surfaces
- Effect of a surface tension gradient on the slip flow along a superhydrophobic air-water interface
- A theory for the slip and drag of superhydrophobic surfaces with surfactant
- Roughness on liquid-infused surfaces induced by capillary waves
- Heat transfer increase by convection in liquid-infused surfaces for laminar and turbulent flows