Absolute calibration of the latent heat of transition using differential thermal analysis
arXiv:2110.05046 · doi:10.1063/5.0056857
Abstract
We describe a simple and accurate differential thermal analysis set up to measure the latent heat of solid state materials undergoing abrupt phase transitions in the temperature range from 77 K to above room temperature. We report a numerical technique for the absolute calibration of the latent heat of the transition, without the need of a reference sample. The technique is applied to three different samples -- vanadium sesquioxide undergoing the Mott transition, bismuth barium ruthenate undergoing a magnetoelastic transition, and an intermetallic Heusler compound. In each case, the inferred latent heat value agrees with the literature value to within its error margins. To further demonstrate the importance of absolute calibration, we show that the changes in the latent heat of the Mott transition in vanadium sesquioxide (VO) stays constant to within 2% even as the depth of supersaturation changes by about 10 K, in non-equilibrium dynamic hysteresis measurements. We also apply this technique for the measurement of the temperature-dependent specific heat.
arXiv commentThis article may be downloaded for personal use only. Any other use requires prior permission of the author and AIP Publishing. This article appeared in Review of Scientific Instruments (volume 92, Issue 7) and may be found at this link (https://doi.org/10.1063/5.0056857)
References in corpus (4)
- Critical Slowing Down at the Abrupt Mott Transition: When the First-Order Phase Transition Becomes Zeroth-Order and Looks Like Second-Order
- Kinetic Spinodal Instabilities in the Mott Transition in V2O3: Evidence from Hysteresis Scaling and Dissipative Phase Ordering
- Direct observation of large temperature fluctuations during DNA thermal denaturation
- Low-temperature differential-thermal analysis to measure variations in entropy