A new technique of linseed oil coating in bakelite RPC and the first test results
arXiv:2108.06923 · doi:10.1016/j.nima.2021.166095
Abstract
Single gap Resistive Plate Chamber (RPC) is one of the very popular gaseous detectors used in high-energy physics experiments nowadays. It is a very fast detector having low cost of fabrication. The RPCs are usually built using glass or bakelite plates having high resistivity ~cm. Bakelite RPCs are generally fabricated with a linseed oil coating inside to make the inner electrode surface smoother which helps to reduce the micro discharge probability. Linseed oil coating also reduces the surface UV sensitivity dramatically and effectively protect the bakelite surfaces from the Hydrofluoric Acid (HF), produced by the interaction of fluorine with the water vapour. There is a conventional way to do this linseed oil coating after making the gas gap as done in experiments ALICE, CMS etc. A new technique is introduced here to do the linseed oil coating on the bakelite plate before making the gas gap. 100\% Tetrafluoroethane (CHF) gas is used to test the RPC module in the avalanche mode with cosmic rays. Conventional NIM electronics is used for this study. The efficiency and noise rate are measured. In this article, the detailed method of fabrication and the first test results are presented.
arXiv comment9 pages, 4 figures
References in corpus (5)
- Performances of linseed oil-free bakelite RPC prototypes with cosmic ray muons
- High Rate Resistive Plate Chamber for LHC detector upgrades
- Performance of the BIS78 RPC detectors: a new concept of electronics and detector integration for high-rate and fast timing large size RPCs
- Development of linseed oil-free bakelite resistive plate chambers
- Characterisation of an RPC prototype with moderate resistivity plates using tetrafluoroethane ()