Development and validation of the signal simulation for the underground muon detector of the Pierre Auger Observatory
arXiv:2104.13253 · doi:10.1088/1748-0221/16/07/P07059
Abstract
The underground muon detector of the Pierre Auger Observatory is aimed at attaining direct measurements of the muonic component of extensive air showers produced by cosmic rays with energy from eV up to the region of the ankle (around eV). It consists of two nested triangular grids of underground scintillators with 433 m, and 750 m spacings and a total of 71 positions, each with 192 scintillator strips (30 m) deployed 2.3 m underground. The light produced by impinging muons in the scintillators is propagated with optical fibers towards an array of silicon photomultipliers. In this work, we present the development, validation, and performance of an end-to-end tool for simulating the response of the underground muon detector to single-muon signals, which constitutes the basis for further simulations of the whole array. Laboratory data and simulation outcomes are found consistent, showing that with the underground muon detector we can measure single muons, with an efficiency of 99 %, up to about 1050 particles arriving at exactly the same time in 30 m of scintillator.
arXiv comment21 pages, 13 figures, 2 tables
References in corpus (10)
- The Pierre Auger Cosmic Ray Observatory
- The Offline Software Framework of the Pierre Auger Observatory
- Features of the energy spectrum of cosmic rays above eV using the Pierre Auger Observatory
- Hybrid simulations of extensive air showers
- Prototype muon detectors for the AMIGA component of the Pierre Auger Observatory
- Muon Counting using Silicon Photomultipliers in the AMIGA detector of the Pierre Auger Observatory
- Design, upgrade and characterization of the silicon photomultiplier front-end for the AMIGA detector at the Pierre Auger Observatory
- A new method for reconstructing the muon lateral distribution with an array of segmented counters
- Calibration of the underground muon detector of the Pierre Auger Observatory
- Design and implementation of the AMIGA embedded system for data acquisition