Comment on "Tuning low-energy scales in YbRhSi by non-isoelectronic substitution and pressure"
arXiv:1910.04108
Abstract
In Ref. 1, Schubert et al. [Phys. Rev. Research 1, 032004 (2019)] reported measurements of the isothermal magnetoresistance of Fe- and Ni-substituted YbRhSi, based on which they raised questions about the Kondo destruction description for the magnetic field-induced quantum critical point (QCP) of pristine YbRhSi. Here we make three points. Firstly, as shown by studies on pristine YbRhSi in Paschen et al. and Friedemann et al., isothermal crossed-field and single-field Hall effect measurements are necessary to ascertain the evolution of the Fermi surface across this QCP. Because Schubert et al. did not carry out such measurements, their results on Fe- and Ni-substituted YbRhSi cannot be used to assess the validity of the Kondo destruction picture neither for substituted nor for pristine YbRhSi. Secondly, when referring to the data of Friedemann et al. on the isothermal crossover of YbRhSi, they did not recognize the implications of the crossover width, quantified by the full width at half maximum (FWHM), being linear in temperature, with zero offset, over about decades in temperature, from 30 mK to 1 K. Finally, in claiming deviations of Hall crossover FWHM data of Friedemann et al. from the above linear-in- dependence they neglected the error bars of these measurements and discarded some of the data points. The claims of Schubert et al. are thus not supported by data, neither previously published nor new (Ref. 1). As such they cannot invalidate the evidence that has been reported for Kondo destruction quantum criticality in YbRhSi.
3 pages, 1 figure; comment on Schubert et al., Phys. Rev. Research 1, 032004 (2019)