Surface slopes of asteroid pairs as indicators of mechanical properties and cohesion

Abstract

Asteroid pairs had a single progenitor that split due to rotational-fission of a weak, rubble-pile structured body. By constructing shape models of asteroid pairs from multiple-apparition observations and using a lightcurve inversion technique, we mapped the gravitational and rotational accelerations on the surfaces of these asteroids. This allows us to construct a map of local slopes on the asteroids' surfaces. In order to test for frictional failure, we determine the maximum rotation rate at which an area larger than half the surface area of the secondary member (assumed to be the ejected component) has a slope value greater than 40 degrees, the angle of friction of lunar regolith, where loose material will begin sliding. We use this criterion to constrain the failure stress operating on the body, just before disruption at the commonly observed spin barrier of 2.2 h. Our current sample includes shape models of eleven primary members of asteroid pairs, observed from the Wise Observatory in the last decade. In the studied parameter space we find that the shape models only reach the spin barrier when their bulk density is larger than the ~2 gr cm-3 measured for the rubble pile structured 25143 Itokawa, suggesting that km-sized asteroid pairs are dense compared to sub-km bodies. Assuming ejection of secondary components that are larger than those observed (up to the maximal size allowing separation), can also increase the spin barrier of the asteroids, thus supporting the previously suggested scenario of continuous disruption of the secondary. In addition, cohesion levels of hundreds of Pascals are also required to prevent these shape models from disrupting at spin rates slower than the usual spin barrier.

Manuscript under review in Icarus

References in corpus (18)

• Dynamics of rotationally fissioned asteroids: Source of observed small asteroid systems
• Formation of asteroid pairs by rotational fission
• Tidal Evolution of Rubble Piles
• Combining asteroid models derived by lightcurve inversion with asteroidal occultation silhouettes
• Landslides and Mass Shedding on Spinning Spheroidal Asteroids
• Volumes and bulk densities of forty asteroids from ADAM shape modeling
• Disintegrating Asteroid P/2013 R3
• Asteroid pairs: a complex picture
• Main Belt Binary Asteroidal Systems With Eccentric Mutual Orbits
• Stress and Failure Analysis of Rapidly Rotating Asteroid (29075) 1950 DA
• The Centurion 18 telescope of the Wise Observatory
• Photometry and Spin Rate Distribution of Small-Sized Main Belt Asteroids
• Adaptive optics and lightcurve data of asteroids: twenty shape models and information content analysis
• Fast Rotation and Trailing Fragments of the Active Asteroid P/2012 F5 (Gibbs)
• Spin Axes and Shape Models of Asteroid Pairs: Fingerprints of YORP and a Path to the Density of Rubble Piles
• Obliquities of "Top-Shaped" Asteroids May Not Imply Reshaping by YORP Spin-up
• Rotation Periods of Binary Asteroids with Large Separations - Confronting the Escaping Ejecta Binaries Model with Observations
• Rotationally Resolved Spectroscopy of Asteroid Pairs: No Spectral Variation Suggests Fission is followed by Settling of Dust

Cited by in corpus (1)

• Orbits of very distant asteroid satellites