Waveforms for the Massive MIMO Downlink: Amplifier Efficiency, Distortion and Performance

Abstract

In massive MIMO, most precoders result in downlink signals that suffer from high PAR, independently of modulation order and whether single-carrier or OFDM transmission is used. The high PAR lowers the power efficiency of the base station amplifiers. To increase power efficiency, low-PAR precoders have been proposed. In this article, we compare different transmission schemes for massive MIMO in terms of the power consumed by the amplifiers. It is found that (i) OFDM and single-carrier transmission have the same performance over a hardened massive MIMO channel and (ii) when the higher amplifier power efficiency of low-PAR precoding is taken into account, conventional and low-PAR precoders lead to approximately the same power consumption. Since downlink signals with low PAR allow for simpler and cheaper hardware, than signals with high PAR, therefore, the results suggest that low-PAR precoding with either single-carrier or OFDM transmission should be used in a massive MIMO base station.

References in corpus (2)

• Optimal Multiuser Transmit Beamforming: A Difficult Problem with a Simple Solution Structure
• Massive MIMO with Non-Ideal Arbitrary Arrays: Hardware Scaling Laws and Circuit-Aware Design

Cited by in corpus (7)

• Uplink Performance of Wideband Massive MIMO with One-Bit ADCs
• Spectral Efficiency of Mixed-ADC Massive MIMO
• Energy Efficient Extreme MIMO: Design Goals and Directions
• Massive-MIMO Iterative Channel Estimation and Decoding (MICED) in the Uplink
• Out-of-Band Radiation Measure for MIMO Arrays with Beamformed Transmission
• The Effect of Spatial Correlation on the Performance of Uplink and Downlink Single-Carrier Massive MIMO Systems
• Model-Driven Deep Learning for Massive Multiuser MIMO Constant Envelope Precoding