Designing an upgrade of the Medley setup for light-ion production and fission cross-section measurements
arXiv:1506.06939 · doi:10.1016/j.nima.2015.05.001
Abstract
Measurements of neutron-induced fission cross sections and light-ion production are planned in the energy range 1-40 MeV at the upcoming Neutrons For Science (NFS) facility. In order to prepare our detector setup for the neutron beam with continuous energy spectrum, a simulation software was written using the Geant4 toolkit for both measurement situations. The neutron energy range around 20 MeV is troublesome when it comes to the cross sections used by Geant4 since data-driven cross sections are only available below 20 MeV but not above, where they are based on semi-empirical models. Several customisations were made to the standard classes in Geant4 in order to produce consistent results over the whole simulated energy range. Expected uncertainties are reported for both types of measurements. The simulations have shown that a simultaneous precision measurement of the three standard cross sections H(n,n), U(n,f) and U(n,f) relative to each other is feasible using a triple layered target. As high resolution timing detectors for fission fragments we plan to use Parallel Plate Avalanche Counters (PPACs). The simulation results have put some restrictions on the design of these detectors as well as on the target design. This study suggests a fissile target no thicker than 2 micrometers (1.7 mg/cm) and a PPAC foil thickness preferably less than 1 micrometer. We also comment on the usability of Geant4 for simulation studies of neutron reactions in this energy range.
arXiv comment11 pages, 8 figures
References in corpus (6)
- Neutron-induced dpa, transmutations, gas production, and helium embrittlement of fusion materials
- A probability-conserving cross-section biasing mechanism for variance reduction in Monte Carlo particle transport calculations
- Light-ion production in the interaction of 96 MeV neutrons with carbon
- High accuracy determination of the U/U fission cross section ratio up to 1 GeV at n_TOF (CERN)
- An iterative procedure to obtain inverse response functions for thick-target correction of measured charged-particle spectra
- Measuring light-ion production and fission cross sections versus elastic np-scattering at the upcoming NFS facility