Measurement and numerical calculation of Rubidium Rydberg Stark spectra
arXiv:1503.08953 · doi:10.1088/1367-2630/17/5/053005
Abstract
We report on the measurement of Stark shifted energy levels of Rb Rydberg atoms in static electric fields by means of electromagnetically induced transparency (EIT). Electric field strengths of up to 500V/cm, ranging beyond the classical ionisation threshold, were applied using electrodes inside a glass cell with rubidium vapour. Stark maps for principal quantum numbers and have been obtained with high signal-to-noise ratio for comparison with results from ab initio calculations following the method described in [M. L. Zimmerman et al., Phys. Rev. A 20, 2251 (1979)], which was originally only verified for states around . We also calculate the dipole matrix elements between low-lying states and Stark shifted Rydberg states to give a theoretical estimate of the relative strength of the EIT signal. The present work significantly extends the experimental verification of this numerical method in the range of both high principal quantum numbers and high electric fields with an accuracy of up to 2MHz.
8 pages, 6 figures
References in corpus (7)
- Progressive field-state collapse and quantum non-demolition photon counting
- Quasiclassical calculations of BBR-induced depopulation rates and effective lifetimes of Rydberg nS, nP and nD alkali-metal atoms with n < 80
- Dipole blockade in a cold Rydberg atomic sample
- Spatially Resolved Excitation of Rydberg Atoms and Surface Effects on an Atom Chip
- Quantum information processing with single photons and atomic ensembles in microwave coplanar waveguide resonators
- Detrimental adsorbate fields in experiments with cold Rydberg gases near surfaces
- Rydberg atoms with a reduced sensitivity to dc and low-frequency electric fields