High-Q operation of SRF cavities: The potential impact of thermocurrents on the RF surface resistance

Abstract

For many new accelerator applications, superconducting radio frequency (SRF) systems are the enabling technology. In particular for CW applications, much effort is being expended to minimize the power dissipation (surface resistance) of niobium cavities. Starting in 2009, we suggested a means of reducing the residual resistance by performing a thermal cycle [1], a procedure of warming up a cavity after initial cooldown to about 20K and cooling it down again. In subsequent studies [2], this technique was used to manipulate the residual resistance by more than a factor of 2. It was postulated that thermocurrents during cooldown generate additional trapped magnetic flux that impacts the cavity quality factor. Here, we present a more extensive study that includes measurements of two additional passband modes and that confirms the effect. In this paper, we also discuss simulations that support the claim. While the layout of the cavity LHe tank system is cylindrically symmetric, we show that the temperature dependence of the material parameters results in a non-symmetric current distribution. Hence a significant amount of magnetic flux can be generated at the RF surface.

submitted to PRST-AB 9 October 2014

References in corpus (3)

• Ultra-high quality factors in superconducting niobium cavities in ambient magnetic fields up to 190 mG
• Reply to "Comment on the 'Decrease of the surface resistance in superconducting niobium resonator cavities by the microwave field'"
• Nitrogen-Doped 9-Cell Cavity Performance in a Test Cryomodule for LCLS-II