Contact Angle Adjustment in Equation of States Based Pseudo-Potential Model

Abstract

Single component pseudo-potential lattice Boltzmann model has been widely applied in multiphase simulation due to its simplicity and stability. In many research, it has been claimed that this model can be stable for density ratios larger than 1000, however, the application of the model is still limited to small density ratios when the contact angle is considered. The reason is that the original contact angle adjustment method influences the stability of the model. Moreover, simulation results in present work show that, by applying the contact angle adjustment method, the density distribution near the wall is artificially changed, and the contact angle is dependent on the surface tension. Hence, it is very inconvenient to apply this method with a fixed contact angle, and the accuracy of the model cannot be guaranteed. To solve these problems, a contact angle adjustment method based on the geometry analysis is proposed and numerically compared with the original method. Simulation results show that, with the new contact angle adjustment method, the stability of the model is highly improved when the density ratio is relatively large, and it is independent of the surface tension.

arXiv comment9 figures

References in corpus (7)

• Simulation of non-ideal gases and liquid-gas phase transitions by lattice Boltzmann equation
• Lattice Boltzmann Simulation of Non-Ideal Fluids
• Lattice Boltzmann modeling of multiphase flows at large density ratio with an improved pseudopotential model
• Multi-component lattice-Boltzmann model with interparticle interaction
• A Lattice Boltzmann method for simulations of liquid-vapor thermal flows
• Achieving tunable surface tension in the pseudopotential lattice Boltzmann modeling of multiphase flows
• Surface Tension Adjustment in a Pseudo-Potential Lattice Boltzmann Model