Electrochemical deposition of FeSe on RABiTS tapes
arXiv:1412.8426 · doi:10.7566/JPSJ.85.015001
Abstract
FeSe film is successfully fabricated onto Rolling Assisted Biaxially Textured Substrate (RABiTS) tapes by an electrochemical deposition technique. The deposited FeSe films tend to become high crystallinity with a decrease in the applied voltage to -1.0 V, and the compositional ratio of Fe to Se approaches 1:1. The sample deposited at -1.0 V shows a superconducting transition approximately 8.0 K in the magnetic susceptibility.
arXiv comment10 pages, 1 figure
References in corpus (18)
- Superconductivity at 36 K in beta-Fe1.01Se with the compression of the interlayer separation under pressure
- Superconductivity at 27 K in tetragonal FeSe under high pressure
- Pressure evolution of low-temperature crystal structure and bonding of 37 K FeSe superconductor
- Very High Field Two-Band Superconductivity in LaFeAsO_0.89F_0.11
- Anion height dependence of Tc for the Fe-based superconductor
- Small anisotropy, weak thermal fluctuations, and high field superconductivity in Co-doped iron pnictide Ba(Fe1-xCox)2As2
- Superconductivity at 32 K in single crystal RbFeSe}
- Observation of superconductivity at 30 K~46 K in AxFe2Se2 (A = Li, Na, Ba, Sr, Ca, Yb, and Eu)
- Synthesis and crystal growth of Cs0.8(FeSe0.98)2: a new iron-based superconductor with Tc=27K
- Crystal structure of the new FeSe1-x superconductor
- Precise Pressure Dependence of the Superconducting Transition Temperature of FeSe: Resistivity and ^77Se--NMR Study
- Transport properties of the new Fe-based superconductor KxFe2Se2 (Tc = 33 K)
- Superconductivity and Magnetic Properties of high-quality single crystals of FeSe ( = K and Cs)
- Fabrication of binary FeSe superconducting wires by novel diffusion process
- Electrodeposition as a new route to synthesize superconducting FeSe
- Superconducting properties of FeSe wires and tapes prepared by gas diffusion technique
- Electrochemical synthesis of iron-based superconductor FeSe films
- Enhancement of superconducting properties in FeSe wires using a quenching technique