Anisotropic interfacial tension, contact angles, and line tensions: A graphics-processing-unit-based Monte Carlo study of the Ising model

Abstract

As a generic example for crystals where the crystal-fluid interface tension depends on the orientation of the interface relative to the crystal lattice axes, the nearest neighbor Ising model on the simple cubic lattice is studied over a wide temperature range, both above and below the roughening transition temperature. Using a thin film geometry $L_x\times L_y\times L_z$ with periodic boundary conditions along the z-axis and two free $L_x\times L_y$ surfaces at which opposing surface fields $\pm H_1$ act, under conditions of partial wetting, a single planar interface inclined under a contact angle $\theta <\pi /2$ relative to the yz-plane is stabilized. In the y-direction, a generalization of the antiperiodic boundary condition is used that maintains the translational invariance in y-direction despite the inhomogeneity of the magnetization distribution in this system. This geometry allows a simultaneous study of the angle-dependent interface tension, the contact angle, and the line tension (which depends on the contact angle, and on temperature). All these quantities are extracted from suitable thermodynamic integration procedures. In order to keep finite size effects as well as statistical errors small enough, rather large lattice sizes (of the order of 46 million sites) are found necessary, availability of very efficient code implementation of graphics processing units (GPUs) was crucial for the feasibility of this study.

arXiv comment22 pages, 14 figures

References in corpus (12)

• Conceptual aspects of line tensions
• Curvature Dependence of Surface Free Energy of Liquid Drops and Bubbles: A Simulation Study
• Quantitative study of laterally inhomogeneous wetting films
• Multi-GPU Accelerated Multi-Spin Monte Carlo Simulations of the 2D Ising Model
• Monte Carlo Test of the Classical Theory for Heterogeneous Nucleation Barriers
• Surface Tension, Surface Stiffness, and Surface Width of the 3-dimensional Ising Model on a Cubic Lattice
• Monte Carlo Methods for Estimating Interfacial Free Energies and Line Tensions
• Fluctuating Interfaces, Surface Tension, and Capillary Waves: An Introduction
• Finite-size scaling for the Ising model on the Moebius strip and the Klein bottle
• Monte Carlo Tests of Nucleation Concepts in the Lattice Gas Model
• Determination of the origin and magnitude of logarithmic finite-size effects on interfacial tension: Role of interfacial fluctuations and domain breathing
• Anisotropy of the interface tension of the three-dimensional Ising model

Cited by in corpus (4)

• Jarzynski's theorem for lattice gauge theory
• Crystal nuclei in melts: A Monte Carlo simulation of a model for attractive colloids
• Step free energies at faceted solid surfaces: Theory and atomistic calculations for steps on the Cu(111) surface
• Three-phase contact line and line tension of electrolyte solutions in contact with charged substrates