Electrothermal Model of Kinetic Inductance Detectors
arXiv:1411.1565 · doi:10.1088/0953-2048/28/4/045012
Abstract
An electrothermal model of Kinetic Inductance Detectors (KIDs) is described. The non-equilibrium state of the resonator's quasiparticle system is characterized by an effective temperature, which because of readout-power heating is higher than that of the bath. By balancing the flow of energy into the quasiparticle system, it is possible to calculate the steady-state large-signal, small-signal and noise behaviour. Resonance-curve distortion and hysteretic switching appear naturally within the framework. It is shown that an electrothermal feedback process exists, which affects all aspects of behaviour. It is also shown that generation-recombination noise can be interpreted in terms of the thermal fluctuation noise in the effective thermal conductance that links the quasiparticle and phonon systems of the resonator. Because the scheme is based on electrothermal considerations, multiple elements can be added to simulate the behaviour of complex devices, such as resonators on membranes, again taking into account readout power heating.
This is an author-created, un-copyedited version of an article published in Superconductor Science and Technology. IOP Publishing Ltd is not responsible for any errors or omissions in this version of the manuscript or any version derived from it. The Version of Record is available online at 10.1088/0953-2048/28/4/045012. Consult Version of Record for changes in response to reviewers
References in corpus (4)
- A semi-empirical model for two-level system noise in superconducting microresonators
- A Position Sensitive X-ray Spectrophotometer using Microwave Kinetic Inductance Detectors
- Position and energy-resolved particle detection using phonon-mediated microwave kinetic inductance detectors
- MKID development for SuperSpec: an on-chip, mm-wave, filter-bank spectrometer