High Fidelity Qubit Readout with the Superconducting Low-Inductance Undulatory Galvanometer Microwave Amplifier
arXiv:1312.7579 · doi:10.1063/1.4871088
Abstract
We describe the high fidelity dispersive measurement of a superconducting qubit using a microwave amplifier based on the Superconducting Low-inductance Undulatory Galvanometer (SLUG). The SLUG preamplifier achieves gain of 19 dB and yields a signal-to-noise ratio improvement of 9 dB over a state-of-the-art HEMT amplifier. We demonstrate a separation fidelity of 99% at 700 ns compared to 59% with the HEMT alone. The SLUG displays a large dynamic range, with an input saturation power corresponding to 700 photons in the readout cavity.
arXiv comment10 pages, 3 figures
References in corpus (23)
- Circuit Quantum Electrodynamics: Coherent Coupling of a Single Photon to a Cooper Pair Box
- Charge insensitive qubit design derived from the Cooper pair box
- Surface codes: Towards practical large-scale quantum computation
- Cavity quantum electrodynamics for superconducting electrical circuits: an architecture for quantum computation
- Coupling Superconducting Qubits via a Cavity Bus
- Demonstration of Two-Qubit Algorithms with a Superconducting Quantum Processor
- Coherent Josephson qubit suitable for scalable quantum integrated circuits
- Preparation and Measurement of Three-Qubit Entanglement in a Superconducting Circuit
- Quantum feedback control of a superconducting qubit: Persistent Rabi oscillations
- AC-Stark Shift and Dephasing of a Superconducting Qubit Strongly Coupled to a Cavity Field
- Complete universal quantum gate set approaching fault-tolerant thresholds with superconducting qubits
- Observation of quantum jumps in a superconducting artificial atom
- Quantum trajectory approach to circuit QED: Quantum jumps and the Zeno effect
- Fast Reset and Suppressing Spontaneous Emission of a Superconducting Qubit
- Loss and decoherence due to stray infrared light in superconducting quantum circuits
- Heralded state preparation in a superconducting qubit
- Initialization by measurement of a two-qubit superconducting circuit
- Protocols for optimal readout of qubits using a continuous quantum nondemolition measurement
- Improved Superconducting Qubit Readout by Qubit-Induced Nonlinearities
- Design and characterization of a lumped element single-ended superconducting microwave parametric amplifier with on-chip flux bias line
- Single-shot readout of a superconducting flux qubit with a flux-driven Josephson parametric amplifier
- Superconducting Low-Inductance Undulatory Galvanometer Microwave Amplifier
- Superconducting Quantum Interference Device Amplifiers with over 27 GHz of Gain-Bandwidth Product Operated in the 4 GHz--8 GHz Frequency Range
Cited by in corpus (10)
- Building logical qubits in a superconducting quantum computing system
- Tunable Superconducting Qubits with Flux-Independent Coherence
- Quantum--Classical Interface Based on Single Flux Quantum Digital Logic
- Optimal dispersive readout of a spin qubit with a microwave resonator
- Active protection of a superconducting qubit with an interferometric Josephson isolator
- Enhancing qubit readout through dissipative sub-Poissonian dynamics
- Implementing generalized measurements with superconducting qubits
- High fidelity single-shot readout of a transmon qubit using a SLUG μwave amplifier
- Reverse isolation and backaction of the SLUG microwave amplifier
- Utilization of the Superconducting Transition for Characterizing Low-Quality-Factor Superconducting Resonators