A system of beam energy measurement based on the Compton backscattered laser photons for the VEPP-2000 electron-positron collider
arXiv:1310.7764 · doi:10.1016/j.nima.2014.01.020
Abstract
The beam energy measurement system for the VEPP-2000 electron-positron collider is described. The method of Compton backscattering of laser photons on the electron beam is used. The relative systematic uncertainty of the beam energy determination is estimated as 6\cdot10^{-5}. It was obtained through comparison of the results of the beam energy measurements using the Compton backscattering and resonance depolarization methods.
14 pages, 12 figures
References in corpus (1)
Cited by in corpus (18)
- Measurement of the cross section from threshold to 1.2 GeV with the CMD-3 detector
- Measurement of the pion form factor with CMD-3 detector and its implication to the hadronic contribution to muon (g-2)
- Atomic physics studies at the Gamma Factory at CERN
- Study of the process in the center-of-mass energy range 1004--1060 MeV with the CMD-3 detector at the VEPP-2000 collider
- The system for delivery of IR laser radiaton into high vacuum
- Measurement of the cross section in the energy range GeV
- Measurement of the process cross section with the SND detector at the VEPP-2000 collider in the energy region GeV
- Measurement of the cross section with the SND detector at the VEPP-2000 collider
- Measurement of the cross section below GeV
- Search for the decay with the SND detector
- Search for direct production of the resonance in collisions
- Upgrade of Beam Energy Measurement System at BEPC-II
- Radiative corrections and Monte Carlo tools for low-energy hadronic cross sections in collisions
- Search for the process
- On a search for the decay at the VEPP-2000 collider
- Beam energy determination in experiments at electron-positron colliders
- Measurement of for meson
- Separation of and events using SND detector calorimeter