Improved Pt() and Ir() astrophysical reactions rates
arXiv:1309.0756 · doi:10.1103/PhysRevC.88.035802
Abstract
Pt is produced solely by the slow neutron capture (\textit{s}) nucleosynthesis process and hence an accurate (,) reaction rate for this nuclide would allow its use as an important calibration point near the termination of the \textit{s}-process nucleosynthesis flow. For this reason, we have measured neutron capture and total cross sections for Pt in the energy range from 10 eV to several hundred keV at the Oak Ridge Electron Linear Accelerator. Measurements on the other Pt isotopes were, in part, necessitated by the fact that only a relatively small Pt sample of modest enrichment was available. Astrophysical Pt() reaction rates, accurate to approximately 3%--5 %, were calculated from these data. No accurate reaction rates have been published previously for any of these isotopes. At \textit{s}-process temperatures, previously recommended rates are larger (by as much as 35%) and have significantly different shapes as functions of temperature, than our new rates. We used our new Pt results, together with Ir(n,) data, to calibrate nuclear statistical model calculations and hence obtain an improved rate for the unmeasured \textit{s}-process branching-point isotope Ir.
Accepted for publication in Phys. Rev. C
Cited by in corpus (5)
- Neutron Reactions in Astrophysics
- The Branchings of the Main s-process: Their Sensitivity to alpha-induced Reactions on 13C and 22Ne and to the Uncertainties of the Nuclear Network
- Uncertainties in s-process nucleosynthesis in low mass stars determined from Monte Carlo variations
- Level densities and thermodynamical properties of Pt and Au isotopes
- Neutron width statistics in a realistic resonance-reaction model