DC and RF Measurements of Serial Bi-SQUID Arrays
arXiv:1212.3748 · doi:10.1109/TASC.2012.2235171
Abstract
SQUID arrays are promising candidates for low profile antennas and low noise amplifier applications. We present the integrated circuit designs and results of DC and RF measurements of the wideband serial arrays based on integration of linear bi-SQUID cells forming a Superconducting Quantum Interference Filter (bi-SQUID SQIF). Various configurations of serial arrays designs are described. The measured linearity, power gain, and noise temperature are analyzed and compared. The experimental results are matched to results of mathematical modeling. A serial bi-SQUID SQIF arrays are mounted into a coplanar waveguide (CPW) and symmetrically grounded to corresponding sides of CPW. The RF output comes out from the central common line, which is also used for DC biasing and forms a symmetrical balanced output. The signal and DC flux biasing line is designed as coplanar lines passed in parallel over each bi-SQUID cell in a bidirectional fashion concentrating magnetic flux inside of each cell. Serial bi-SQUID SQIF arrays are fabricated on 5 mm x 5 mm chips using standard HYPRES niobium 4.5 kA/cm2 fabrication process.
arXiv comment7 pages, 10 figures, Applied Superconductivity Conference (ASC'12)
References in corpus (5)
- Disorder Effects in Superconducting Multiple Loop Quantum Interferometers
- Nonperiodic Flux to Voltage Conversion of an Arithmetic Series Array of dc SQUIDs
- Active Electrically Small Antenna Based on Superconducting Quantum Array
- Development of 2D Bi-SQUID Arrays with High Linearity
- Two tone response of radiofrequency signals using the voltage output of a Superconducting Quantum Interference Filter
Cited by in corpus (5)
- Development of 2D Bi-SQUID Arrays with High Linearity
- Multistability and Self-Organization in Disordered SQUID Metamaterials
- Analytical derivation of DC SQUID response
- A linear magnetic flux-to-voltage transfer function of differential DC SQUID
- Superconducting Electronic Device Response Linearity Calculation Method Using Discrete Fourier Analysis