Cratering Experiments on the Self Armoring of Coarse-Grained Granular Targets
arXiv:1206.5564 · doi:10.1016/j.icarus.2012.06.041
Abstract
Recently published crater statistics on the small asteroids 25143 Itokawa and 433 Eros show a significant depletion of craters below approx. 100 m in diameter. Possible mechanisms that were brought up to explain this lack of craters were seismic crater erasure and self armoring of a coarse, boulder covered asteroid surface. While seismic shaking has been studied in this context, the concept of armoring lacks a deeper inspection and an experimental ground truth. We therefore present cratering experiments of glass bead projectiles impacting into granular glass bead targets, where the grain sizes of projectile and target are in a similar range. The impact velocities are in the range of 200 to 300 m/s. We find that craters become fainter and irregular shaped as soon as the target grains are larger than the projectile sizes and that granular craters rarely form when the size ratio between projectile and target grain is around 1:10 or smaller. In that case, we observe a formation of a strength determined crater in the first struck target grain instead. We present a simple model based on the transfer of momentum from the projectile to this first target grain, which is capable to explain our results with only a single free parameter, which is moreover well determined by previous experiments. Based on estimates of typical projectile size and boulder size on Itokawa and Eros, given that our results are representative also for km/s impact velocities, armoring should play an important role for their evolution.
arXiv commentaccepted for publication in Icaurs
References in corpus (1)
Cited by in corpus (7)
- Granular Impact Model as an Energy-Depth Relation
- Collisional Model of Energy Dissipation in 3D Granular Impact
- The spatial distribution of impact craters on Ryugu
- Measuring the Fidelity of Asteroid Regolith and Cobble Simulants
- Regolith behavior under asteroid-level gravity conditions: Low-velocity impacts into mm- and cm-sized grain targets
- Impact cratering on porous targets in the strength regime
- Stagnant Zone Formation in a 2D Bed of Circular and Elongated Grains under Penetration