paper

Lift Evaluation of a 2D Flapping Flat Plate

arXiv:1205.6853 · doi:10.1063/1.4819878

Abstract

Several previous experimental and theoretical studies have shown that a leading edge vortex (LEV) on an airfoil or wing can provide lift enhancement. In this paper, unsteady 2D potential flow theory is employed to model the flow field of a flapping flat plate wing. A multi-vortices model is developed to model both the leading edge and trailing edge vortices (TEVs), which offers improved accuracy compared with using only single vortex at each separation location. The lift is obtained by integrating the unsteady Blasius equation. It is found that the motion of vortices contributes significantly to the overall aerodynamic force on the flat plate. The shedding of TEVs and the stabilization of LEVs explicitly contributes to lift enhancement. A Kutta-like condition is used to determine the vortex intensity and location at the leading edge for large angle of attack cases; however, it is proposed to relax this condition for small angle of attack cases and apply a 2D shear layer model to calculate the circulation of the new added vortex. The results of the simulation are then compared with classical numerical, modeled and experimental data for canonical unsteady flat plat problems. Good agreement with these data is observed. Moreover, these results suggested that the leading edge vortex shedding for small angles of attack should be modeled differently than that for large angles of attack. Finally, the results of vortex motion vs. lift indicate that both a motion against the streamwise direction of the LEV and a streamwise motion of the TEV contributes positive lift. This also provides the insights for future active flow control of MAVs that the formation and shedding process of LEVs and TEVs can be manipulated to provide lift enhancement.

Cited by in corpus (9)