Intergrain forces in low Mach-number plasma wakes
arXiv:1204.5076 · doi:10.1103/PhysRevE.85.066409
Abstract
Large-scale particle-in-cell calculations of the plasma wake interactions of two negatively charged grains smaller than the Debye length are carried out using the COPTIC code over a wide range of subsonic plasma flow velocities. In plasmas with temperature ratio , it is found that a single grain's oscillatory wake disappears for flow Mach numbers () less than approximately 0.3, which is the parameter regime where Landau damping is expected to be strong. Neutral collisions suppress potential oscillations above , but not the trailing attractive potential peak caused by ion focussing. The transverse (grain-aligning) force on a downstream particle in the wake of another is obtained rigorously from the code in three-dimensional simulations. It shows general agreement with the force that would be deduced from the single-grain wake potential gradient. Except for relatively large grains in the nonlinear collisional regime, the grain-aligning force is very small for slow flow.
15 pages, 11 figures, submitted to Phys Rev E
References in corpus (2)
Cited by in corpus (12)
- Collisional Effects on Nonlinear Ion Drag Force for Small Grains
- Dust charging in dynamic ion wakes
- Screened Coulomb potential in a flowing magnetized plasma
- Dust as probes: determining confinement and interaction forces
- Ion-wake Field inside a Glass Box
- Influence of Temporal Variations in Plasma Conditions on the Electric Potential Near Self-Organized Dust Chains
- Effect of ionization waves on dust chain formation in a DC discharge
- Wakes in inhomogeneous plasmas
- Configurational temperature in dusty plasmas
- Collision induced amplification of wakes in streaming plasmas
- OpenDust: A fast GPU-accelerated code for calculation forces, acting on microparticles in a plasma flow
- Evolution of Ion Wake Characteristics with Experimental Conditions