Millikelvin thermal and electrical performance of lossy transmission line filters
arXiv:0903.1895 · doi:10.1063/1.3133362
Abstract
We report on the scattering parameters and Johnson noise emission of low-pass stripline filters employing a magnetically loaded silicone dielectric down to 25 mK. The transmission characteristic of a device with =1.3 GHz remains essentially unchanged upon cooling. Another device with =0.4 GHz, measured in its stopband, exhibits a steady state noise power emission consistent with a temperature difference of a few mK relative to a well-anchored cryogenic microwave attenuator at temperatures down to 25 mK, thus presenting a matched thermal load.
4 pages, 4 figures
References in corpus (2)
Cited by in corpus (11)
- Thermal and Residual Excited-State Population in a 3D Transmon Qubit
- Measuring a topological transition in an artificial spin 1/2 system
- Photon Shot Noise Dephasing in the Strong-Dispersive Limit of Circuit QED
- Measurement-induced qubit state mixing in circuit QED from up-converted dephasing noise
- Microwave calibration of qubit drive line components at millikelvin temperatures
- Low-pass filter with ultra-wide stopband for quantum computing applications
- Impedance Matched Absorptive Thermal Blocking Filters
- Microstrip filters for measurement and control of superconducting qubits
- Efficient Radio Frequency filters for space constrained cryogenic set-ups
- Absorptive filters for quantum circuits: Efficient fabrication and cryogenic power handling
- Josephson squelch filter for quantum nanocircuits