Comparisons of the MINOS Near and Far Detector Readout Systems at a Test Beam
arXiv:0902.1116 · doi:10.1016/j.nima.2009.07.016
Abstract
MINOS is a long baseline neutrino oscillation experiment that uses two detectors separated by 734 km. The readout systems used for the two detectors are different and have to be independently calibrated. To verify and make a direct comparison of the calibrated response of the two readout systems, test beam data were acquired using a smaller calibration detector. This detector was simultaneously instrumented with both readout systems and exposed to the CERN PS T7 test beam. Differences in the calibrated response of the two systems are shown to arise from differences in response non-linearity, photomultiplier crosstalk, and threshold effects at the few percent level. These differences are reproduced by the Monte Carlo (MC) simulation to better than 1% and a scheme that corrects for these differences by calibrating the MC to match the data in each detector separately is presented. The overall difference in calorimetric response between the two readout systems is shown to be consistent with zero to a precision of 1.3% in data and 0.3% in MC with no significant energy dependence.
arXiv comment25 pages, 8 figures
References in corpus (4)
Cited by in corpus (10)
- Improved search for muon-neutrino to electron-neutrino oscillations in MINOS
- The magnetized steel and scintillator calorimeters of the MINOS experiment
- Measurement of the neutrino mass splitting and flavor mixing by MINOS
- Search for sterile neutrinos in MINOS and MINOS+ using a two-detector fit
- Study of quasielastic scattering using charged-current nu_mu-iron interactions in the MINOS Near Detector
- New constraints on muon-neutrino to electron-neutrino transitions in MINOS
- Search for muon-neutrino to electron-neutrino transitions in MINOS
- A Review of Long-baseline Neutrino Oscillation Experiments
- MINOS neutrino oscillation results
- MINERvA neutrino detector response measured with test beam data