Strong enhancement of Jc in binary and alloyed in-situ MgB2 wires by a new approach: Cold high pressure densification
arXiv:0901.4546 · doi:10.1088/0953-2048/22/8/085002
Abstract
Cold high pressure densification (CHPD) is presented as a new way to substantially enhance the critical current density of in situ MgB2 wires at 4.2 and 20 K at fields between 5 and 14 T. The results on two binary MgB2 wires and an alloyed wire with 10 wt.% B4C are presented The strongest enhancement was measured at 20K, where cold densification at 1.85 GPa on a binary Fe/MgB2 wire raised both Jcpara and Jcperp by more than 300% at 5T, while Birr was enhanced by 0.7 T. At 4.2K, the enhancement of Jc was smaller, but still reached 53% at 10 T. After applying pressures up to 6.5 GPa, the mass density dm of the unreacted (B+Mg) mixture inside the filaments reached 96% of the theoretical density. After reaction under atmospheric pressure, this corresponds to a highest mass density df in the MgB2 filaments of 73%. After reaction, the electrical resistance of wires submitted to cold densification was found to decrease, reflecting an improved connectivity. A quantitative correlation between filament mass density and the physical properties was established. Monofilamentary rectangular wires with aspect ratios a/b < 1.25 based on low energy ball milled powders exhibited very low anisotropy ratios, Gamma = Jcpara/Jcperp being < 1.4 at 4.2 K and 10T. The present results can be generalized to alloyed MgB2 wires, as demonstrated on a wire with B4C additives. Based on the present data, it follows that cold densification has the potential of further improving the highest Jcpara and Jcperp values reported so far for in situ MgB2 tapes and wires with SiC and C additives. Investigations are under work in our laboratory to determine whether the densification method CHPD can be applied to longer wire or tape lengths.
arXiv commentSubmitted to Superconductors Science and Technology
References in corpus (9)
- Enhancement of the critical current density and flux pinning of MgB2 superconductor by nanoparticle SiC doping
- Systematic effects of carbon doping on the superconducting properties of Mg(BC)
- Carbon-substituted MgB2 single crystals
- Prospects for Improving the Intrinsic and Extrinsic Properties of Magnesium Diboride Superconducting Strands
- Hot isostatic pressing of powder in tube MgB2 wires
- Effect of aromatic hydrocarbon addition on in situ powder-in-tube processed MgB2 tapes
- Improved critical current densities in B4C doped MgB2 based wires
- Properties of superconducting MgB_2 wires: "in-situ" versus "ex-situ" reaction technique
- Correlation between doping induced disorder and superconducting properties in carbohydrate doped MgB2
Cited by in corpus (3)
- The critical current density of advanced internal-Mg-diffusion-processed MgB2 wires
- Critical Current Density and n-values of MgB2 Strands over a Wide Range of Temperatures and Fields
- Large enhancement of transport critical current density of ex-situ PIT Ag/(Ba,K)Fe2As2 tapes achieved by applying cycles of cold deformation and heat treatment