Local Alignment of the BABAR Silicon Vertex Tracking Detector
arXiv:0809.3823 · doi:10.1016/j.nima.2009.02.001
Abstract
The BABAR Silicon Vertex Tracker (SVT) is a five-layer double-sided silicon detector designed to provide precise measurements of the position and direction of primary tracks, and to fully reconstruct low-momentum tracks produced in e+e- collisions at the PEP-II asymmetric collider at Stanford Linear Accelerator Center. This paper describes the design, implementation, performance, and validation of the local alignment procedure used to determine the relative positions and orientations of the 340 SVT wafers. This procedure uses a tuned mix of in-situ experimental data and complementary lab-bench measurements to control systematic distortions. Wafer positions and orientations are determined by minimizing a chisquared computed using these data for each wafer individually, iterating to account for between-wafer correlations. A correction for aplanar distortions of the silicon wafers is measured and applied. The net effect of residual mis-alignments on relevant physical variables is evaluated in special control samples. The BABAR data-sample collected between November 1999 and April 2008 is used in the study of the SVT stability.
arXiv comment21 pages, 20 figures, 3 tables, submitted to Nucl. Instrum. Meth. A
References in corpus (2)
Cited by in corpus (8)
- Alignment of the CMS Silicon Tracker during Commissioning with Cosmic Rays
- Measurement of the weak mixing angle with the Drell-Yan process in proton-proton collisions at the LHC
- The global covariance matrix of tracks fitted with a Kalman filter and an application in detector alignment
- Alignment of the CMS tracker with LHC and cosmic ray data
- Application of vertex and mass constraints in track-based alignment
- Strategies and performance of the CMS silicon tracker alignment during LHC Run 2
- Precise measurement of the and lifetimes at Belle II
- Validation of Kalman Filter alignment algorithm with cosmic-ray data using a CMS silicon strip tracker endcap