Measurement of dispersive forces between evaporated metal surfaces in the range below 100 nm
arXiv:0712.3118 · doi:10.1063/1.2832664
Abstract
In this work we describe dispersion force (van der Waals/Casimir) measurements between gold surfaces at separations as close as 12 nm. The force measurements were performed in the plane-sphere configuration by Atomic Force Microscopy at distances ranging between 12 and 200 nm. This was accomplished by using evaporated smooth metal surfaces for both sphere and plane, and stiff cantilevers to minimize jump-to-contact problems. Finally, it is shown that below separations of 100 nm experiment and theory are found in agreement within 10 % by including in the theory the measured optical properties of gold and contribution from surface roughness.
14 pages, 3 figures
References in corpus (7)
- Novel constraints on light elementary particles and extra-dimensional physics from the Casimir effect
- Influence of random roughness on the Casimir force at small separations
- Demonstration of the difference Casimir force for samples with different charge carrier densities
- Experimental test for the conductivity properties from the Casimir force between metal and semiconductor
- Sample dependence of the Casimir forces
- Influence of random roughness on the adhesion between metal surfaces due to capillary condensation
- Roughness corrections to the Casimir force: The importance of local surface slope