output
20022011
most citedHeavy quarkonium: progress, puzzles, and opportunities

1.8k citations

Showing 2011Show all

59 papers · 1 filter

physics.geo-ph20111 cited

Critical speed-up vs critical slow-down: a new kind of relaxation oscillation with application to stick-slip phenomena

Yves Pomeau, Martine Le Berre

The equations for the sliding of a single block driven by an elastic force show numerically a fast and a slow step in their dynamics when a dimensionless parameter is very large, a…

cond-mat.mtrl-sci201152 cited

Low energy graphene edge termination via small diameter nanotube formation

Viktoria V. Ivanovskaya, Alberto Zobelli, Philipp Wagner +4

We demonstrate that free graphene sheet edges can curl back on themselves,reconstructing as nanotubes. This results in lower formation energies than any other non-functionalised ed…

hep-ex201163 cited

Bounds on an anomalous dijet resonance in W+jets production in ppbar collisions at sqrt{s} =1.96 TeV

D0 Collaboration, V. Abazov

We present a study of the dijet invariant mass spectrum in events with two jets produced in association with a W boson in data corresponding to an integrated luminosity of 4.3 fb^-…

math.AP2011

On the attractive plasma-charge system in 2-d

Silvia Caprino, Carlo Marchioro, Evelyne Miot +1

We study a positively charged Vlasov-Poisson plasma in which N negative point charges are immersed. The attractiveness of the system forces us to consider a possibly unbounded plas…

cond-mat.stat-mech2011147 cited

First passages for a search by a swarm of independent random searchers

C. Mejia-Monasterio, G. Oshanin, G. Schehr

In this paper we study some aspects of search for an immobile target by a swarm of N non-communicating, randomly moving searchers (numbered by the index k, k = 1, 2,..., N), which…

cs.OH201166 cited

Characterization of 3D surface topography in 5-axis milling

Yann Quinsat, Sylvain Lavernhe, Claire Lartigue

Within the context of 5-axis free-form machining, CAM software offers various ways of tool-path generation, depending on the geometry of the surface to be machined. Therefore, as t…