1.4k citations
Counting papers with at most 25 authors, so collaboration author lists do not stand in for the people here.
- University of HelsinkiFI1.3k papers
- University of AntwerpBE1.3k papers
- UCLouvainBE1.3k papers
- Vrije Universiteit BrusselBE1.3k papers
- Universidade do Estado do Rio de JaneiroBR1.3k papers
- University of CyprusCY1.3k papers
- University of SplitHR1.3k papers
- National Institute of Chemical Physics and BiophysicsEE1.3k papers
- RWTH Aachen UniversityDE1.3k papers
- Université Libre de BruxellesBE1.3k papers
- Peking UniversityCN1.3k papers
- Sofia University "St. Kliment Ohridski"BG1.3k papers
26 papers · 1 filter
Characterisation of Gamma-irradiated MCz-Silicon Detectors with a High- Negative Oxide as Field Insulator
S. Bharthuar, M. Bezak, E. Brücken +10
The high-luminosity operation of the Tracker in the Compact Muon Solenid (CMS) detector at the Large Hadron Collider (LHC) experiment calls for the development of silicon-based sen…
Quality assessment of Cadmium Telluride as a detector material for multispectral medical imaging
S. Kirschenmann, M. Bezak, S. Bharthuar +12
Cadmium Telluride (CdTe) is a high-Z material with excellent photon radiation absorption properties, making it a promising material to include in radiation detection technologies.…
Employing infrared microscopy (IRM) in combination with a pre-trained neural network to visualise and analyse the defect distribution in Cadmium Telluride crystals
S. Kirschenmann, S. Bharthuar, E. Brücken +6
While Cadmium Telluride (CdTe) excels in terms of photon radiation absorption properties and outperforms silicon (Si) in this respect, the crystal growth, characterization and proc…
Modeling the triple-GEM detector response to background particles for the CMS Experiment
M. Abbas, M. Abbrescia, H. Abdalla +186
An estimate of environmental background hit rate on triple-GEM chambers is performed using Monte Carlo (MC) simulation and compared to data taken by test chambers installed in the…
Performance of a Triple-GEM Demonstrator in Collisions at the CMS Detector
M. Abbas, M. Abbrescia, H. Abdalla +178
After the Phase-2 high-luminosity upgrade to the Large Hadron Collider (LHC), the collision rate and therefore the background rate will significantly increase, particularly in the…
Interstrip Capacitances of the Readout Board used in Large Triple-GEM Detectors for the CMS Muon Upgrade
M. Abbas, M. Abbrescia, H. Abdalla +178
We present analytical calculations, Finite Element Analysis modeling, and physical measurements of the interstrip capacitances for different potential strip geometries and dimensio…
Reconstruction of signal amplitudes in the CMS electromagnetic calorimeter in the presence of overlapping proton-proton interactions
CMS Collaboration
A template fitting technique for reconstructing the amplitude of signals produced by the lead tungstate crystals of the CMS electromagnetic calorimeter is described. This novel app…
Multispectral Photon-Counting for Medical Imaging and Beam Characterization
E. Brücken, S. Bharthuar, M. Emzir +18
We present the current status of our project of developing a photon counting detector for medical imaging. An example motivation lays in producing a monitoring and dosimetry device…
Measurements with silicon photomultipliers of dose-rate effects in the radiation damage of plastic scintillator tiles in the CMS hadron endcap calorimeter
CMS Collaboration
Measurements are presented of the reduction of signal output due to radiation damage for plastic scintillator tiles used in the hadron endcap (HE) calorimeter of the CMS detector.…
Experimental Study of Different Silicon Sensor Options for the Upgrade of the CMS Outer Tracker
The Tracker Group of the CMS Collaboration
During the high-luminosity phase of the LHC (HL-LHC), planned to start around 2027, the accelerator is expected to deliver an instantaneous peak luminosity of up to $7.5\times10^{3…
Performance of the reconstruction and identification of high-momentum muons in proton-proton collisions at 13 TeV
CMS Collaboration
The CMS detector at the LHC has recorded events from proton-proton collisions, with muon momenta reaching up to 1.8 TeV in the collected dimuon samples. These high-momentum muons a…
Calibration of the CMS hadron calorimeters using proton-proton collision data at 13 TeV
CMS Collaboration
Methods are presented for calibrating the hadron calorimeter system of the CMS detector at the LHC. The hadron calorimeters of the CMS experiment are sampling calorimeters of brass…
Performance of prototype GE1/1 chambers for the CMS muon spectrometer upgrade
CMS Muon Group
The high-luminosity phase of the Large Hadron Collider (HL-LHC) will result in ten times higher particle background than measured during the first phase of LHC operation. In order…
Layout and Assembly Technique of the GEM Chambers for the Upgrade of the CMS First Muon Endcap Station
Aashaq Shah, CMS-Muon Collaboration
Triple-GEM detector technology was recently selected by CMS for a part of the upgrade of its forward muon detector system as GEM detectors provide a stable operation in the high ra…
Precision measurement of the structure of the CMS inner tracking system using nuclear interactions
CMS Collaboration
The structure of the CMS inner tracking system has been studied using nuclear interactions of hadrons striking its material. Data from proton-proton collisions at a center-of-mass…
Performance of the CMS muon detector and muon reconstruction with proton-proton collisions at 13 TeV
CMS Collaboration
The CMS muon detector system, muon reconstruction software, and high-level trigger underwent significant changes in 2013-2014 in preparation for running at higher LHC collision ene…
Identification of heavy-flavour jets with the CMS detector in pp collisions at 13 TeV
CMS Collaboration
Many measurements and searches for physics beyond the standard model at the LHC rely on the efficient identification of heavy-flavour jets, i.e. jets originating from bottom or cha…
Particle-flow reconstruction and global event description with the CMS detector
CMS Collaboration
The CMS apparatus was identified, a few years before the start of the LHC operation at CERN, to feature properties well suited to particle-flow (PF) reconstruction: a highly-segmen…
Test Beam Performance Measurements for the Phase I Upgrade of the CMS Pixel Detector
M. Dragicevic, M. Friedl, J. Hrubec +481
A new pixel detector for the CMS experiment was built in order to cope with the instantaneous luminosities anticipated for the Phase~I Upgrade of the LHC. The new CMS pixel detecto…
Mechanical stability of the CMS strip tracker measured with a laser alignment system
CMS Collaboration
The CMS tracker consists of 206 square meters of silicon strip sensors assembled on carbon fibre composite structures and is designed for operation in the temperature range from -2…
The CMS trigger system
CMS Collaboration
This paper describes the CMS trigger system and its performance during Run 1 of the LHC. The trigger system consists of two levels designed to select events of potential physics in…
Fiber Bragg Grating (FBG) sensors as flatness and mechanical stretching sensors
D. Abbaneo, M. Abbas, M. Abbrescia +153
A novel approach which uses Fibre Bragg Grating (FBG) sensors has been utilised to assess and monitor the flatness of Gaseous Electron Multipliers (GEM) foils. The setup layout and…
Trapping in irradiated p-on-n silicon sensors at fluences anticipated at the HL-LHC outer tracker
W. Adam, T. Bergauer, M. Dragicevic +682
The degradation of signal in silicon sensors is studied under conditions expected at the CERN High-Luminosity LHC. 200 m thick n-type silicon sensors are irradiated with protons…
CMS Tracking Performance Results from early LHC Operation
The CMS Collaboration
The first LHC pp collisions at centre-of-mass energies of 0.9 and 2.36 TeV were recorded by the CMS detector in December 2009. The trajectories of charged particles produced in the…